Contemporary-control-systems EISC Configurable Switches User Manual Instrukcja Użytkownika Pobierz pdf (Strona 11)

TD021000-0MB

Installation

5.1 Hardware

5.1.1 Mounting

The EISC is designed for mounting in an industrial enclosure or wiring closet using

either set of the provided mounting hardware listed below:

TS-35 DIN-rail Mounting

Panel Mounting

DIN-rail clip

Panel mounting bracket

DIN-rail clip support bracket

4-40 screws, flat-head (4)

4-40 screws, pan-head (2)

For quick snap-mounting to 35 mm DIN-rail, a reinforced DIN-rail clip is pre-attached to

the back of the EISC enclosure with two #4-40 pan-head screws. If the clip is removed,

the EISC can be panel-mounted by extending the top and bottom brackets which are

shipped in retracted position. The extended brackets can then anchor the EISC to a

wall or other flat vertical surface with two #8 pan-head screws (not provided). The left

illustration of Figure 2 shows a rear view of the EISC with brackets in retracted position.

The right illustration of Figure 2 shows the brackets extended and secured to the EISC

enclosure with the same screws used in retracted position.

Figure 2 — Using the Panel-Mounting Brackets

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Brak uwag

Contemporary-control-systems EISC Configurable Switches User Manual Instrukcja Użytkownika Strona 11